Configuring Qos In The Cisco Ip Phone 7960 - Cisco WS-C6506 Software Manual

Chapter 55 Configuring a VoIP Network
Receive bytes
Receive packets
Transmit bytes
Transmit packets
Channel #3:
.
(display text omitted)
.
Console>
This example shows how to display a specific call at a specified IP address:
Console> show port voice active 3/2 171.69.67.91
Remote IP address
Remote UDP port
Call state
Codec Type
Coder Type Rate
Tx duration
Voice Tx duration
ACOM Level Current
ERL Level
Fax Transmit Duration
Hi Water Playout Delay
Logical If index
Low water playout delay
Receive delay
Receive bytes
Receive packets
Transmit bytes
Transmit packets
Console>

Configuring QoS in the Cisco IP Phone 7960

These sections describe QoS in the Cisco IP Phone 7960:
•
•
For information on using automatic QoS, see
Note
For information on using automatic voice configuration, see the
Note
page
Understanding How QoS Works in the Cisco IP Phone 7960
Note The Cisco IP Phone 7960 always sets the Layer 3 IP precedence and Layer 2 CoS to 5 in the voice traffic
that is generated by the phone. The Layer 3 IP precedence and Layer 2 CoS values in the voice traffic
that is generated by the phone are not configurable.
OL-8978-04
Understanding How QoS Works in the Cisco IP Phone 7960, page 55-31
Configuring QoS in the Cisco IP Phone 7960, page 55-32
55-38.
: 2342342332423
: 23423423402384
: 23472377
: 94540
: 171.69.67.91
: 125
: Ringing
: G.711
: 35243
: 438543 sec
: 34534 sec
: 123213
: 123 dB
: 332433
: 23004 ms
: 4
: 234 ms
: 23423 ms
: 2342342332423
: 23423423402384
: 23472377
: 94540
Chapter 53, "Using Automatic QoS."
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring VoIP on a Switch
"Using SmartPorts" section on
55-31