Storing Dhcp-Snooping Binding Entries To A Flash Device - Cisco WS-C6506 Software Manual

Chapter 33 Configuring DHCP Snooping and IP Source Guard
5/12
5/13
5/14
5/15
5/16
5/17
5/18
5/19
5/20
5/21
5/22
5/23
5/24
Console> (enable)

Storing DHCP-Snooping Binding Entries to a Flash Device

The DHCP-snooping binding entries can be stored to a flash device so the bindings can be restored
immediately after the switch is reset.
The auto-save interval option is for configuring the auto-save interval for DHCP-snooping bindings.
Valid ranges for the interval are 1 through 35000 minutes. Specifying a 0 disables the periodic saving of
bindings on the flash device and deletes the bindings file stored in flash. Specifying a 0 does not clear a
user-specified filename. The user-specified filename is cleared and returned to the default filename after
the clear config all command is entered.
The device:filename option is for specifying the flash device and filename for storing the bindings. By
default, the flash device is bootflash and the default filename is dhcp-snooping-bindings-database. If you
have not configured a filename, the bindings are automatically saved with the default filename on the
flash device.
To enable the auto-save option for DHCP-snooping binding entries and specify the interval to periodically
save the bindings, perform this task in privileged mode:
Task
Enable the auto-save option for
DHCP-snooping binding entries and specify
the interval to periodically save the bindings.
This example shows how to enable the auto-save option for DHCP-snooping binding entries and specify
an interval of 600 minutes to periodically save the bindings:
Console> (enable) set dhcp-snooping bindings-database auto-save 600
DHCP Snooping auto-save interval set to 600 minutes.
Console> (enable)
To specify the flash device and filename for storing the bindings, perform this task in privileged mode:
Task
Specify the flash device and filename for
storing the bindings.
This example shows how to specify the flash device and filename for storing the bindings:
Console> (enable) set dhcp-snooping bindings-database disk1:dhcp-bindings
OL-8978-04
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
32 0
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Storing DHCP-Snooping Binding Entries to a Flash Device
Command
set dhcp-snooping bindings-database auto-save interval
Command
set dhcp-snooping bindings-database device:[filename]
33-15