Configuring Metro Ethernet Connectivity Fault Management - Cisco WS-C6506 Software Manual

Configuring Metro Ethernet Connectivity Fault Management

Displaying Ethernet OAM Statistics
To display OAM statistics, perform this task in normal mode:
Task
Display OAM statistics.
This example shows how to display OAM statistics for port 1/2:
Console> (enable) show port ethernet-oam 1/2 statistics
Port
----- ---------- ---------- ---------- ---------- ---------- ----------
1/2
Port
----- ---------- ---------- ---------- ---------- ---------- ----------
1/2
Port
----- ---------- ---------- ---------- ----------
1/2
Port
----- ---------- ---------- ---------- ----------
1/2
Console> (enable)
Configuring Metro Ethernet Connectivity Fault Management
This section describes how to configure Metro Ethernet Connectivity Fault Management (CFM). CFM
is part of the Metro Ethernet OAM feature.
These sections describe how to configure Metro Ethernet CFM:
•
•
•
•
•
•
•
•
•
•
•
•
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
20-38
InfoPduRx UniEventRx DupEventRx RLBCtrlRx
2579 0
InfoPduTx UniEventTx DupEventTx RLBCtrlTx
2571 0
OrgSpecRx UnknownRx
0 0
OrgSpecTx UnknownTx
0 0
Understanding How Metro Ethernet Connectivity Fault Management Works, page 20-39
Connectivity Fault Management Protocols, page 20-39
Maintenance Domains, page 20-39
Maintenance Associations, page 20-40
Maintenance Points, page 20-40
CFM Configuration Guidelines and Restrictions, page 20-42
Configuring Metro Ethernet CFM, page 20-44
Understanding How CFM Works with 802.3ah Link-OAM for AIS-RDI, page 20-55
Ethernet Alarm Indication Signal, page 20-55
Ethernet Remote Defect Indication, page 20-56
ASI and RDI Configuration Guidelines and Restrictions, page 20-56
Configuring an Alarm Indication Signal, page 20-57
Command
show port ethernet-oam [mod | mod/port]
statistics
0 0
0 1
CiscoPduRx CiscoTLVRx
0 1
CiscoPduTx CiscoTLVTx
0 0
Chapter 20 Checking Status and Connectivity
VarReqRx VarResRx
0 0
VarReqTx VarResTx
0 0
OL-8978-04