Cisco WS-C6506 Software Manual page 1340

Using the Automatic QoS Macro on the Switch
Global Automatic QoS Macro
When you execute the global automatic QoS macro, all the global QoS settings are applied to all ports
in the switch. After completion, a prompt displays showing the CLI for the port-based automatic QoS
commands that are currently supported.
Console> (enable) set qos autoqos ?
Usage: set qos autoqos
Console> (enable) set qos autoqos
QoS is enabled.
........
All ingress and egress QoS scheduling parameters configured on all ports.
CoS to DSCP, DSCP to COS, IP Precedence to DSCP and policed dscp maps configured.
Global QoS configured, port specific autoqos recommended:
Console> (enable)
Port-Specific Automatic QoS Macro
The port-specific automatic QoS macro accepts a mod/port combination and must include an
AVVID-type keyword. The ciscoipphone, ciscosoftphone, and trust keywords are supported.
This example shows how to use the ciscoipphone keyword:
Console> (enable) set port qos 3/1 autoqos help
Usage: set port qos <mod/port> autoqos trust <cos|dscp>
Console> (enable) set port qos 3/1 autoqos voip ciscoipphone
Port 3/1 ingress QoS configured for Cisco IP Phone.
It is recommended to execute the "set qos autoqos" global command if not executed
previously.
Console> (enable)
This example shows how to use the ciscosoftphone keyword:
Console> (enable) set port qos 3/1 autoqos voip ciscosoftphone
Port 3/1 ingress QoS configured for Cisco Softphone.
It is recommended to execute the "set qos autoqos" global command if not executed
previously.
Console> (enable)
This example shows how to use the trust cos keyword:
Console> (enable) set port qos 3/1 autoqos trust cos
Port 3/1 QoS configured to trust all incoming CoS marking.
It is recommended to execute the "set qos autoqos" global command if not executed
previously.
Console> (enable)
This example shows how to use the trust dscp keyword:
Console> (enable) set port qos 3/1 autoqos trust dscp
Port 3/1 QoS configured to trust all incoming DSCP marking.
It is recommended to execute the "set qos autoqos" global command if not executed
previously.
Console> (enable)
Displaying the QoS Settings
Enter the existing QoS show commands to display the QoS settings. These commands include the show
port qos and show qos info runtime commands.
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
53-14
set qos autoqos
—
set port qos <mod/port> autoqos trust <cos|dscp>
set port qos <mod/port> autoqos voip <ciscoipphone|ciscosoftphone>
set port qos autoqos
—
set port qos <mod/port> autoqos voip <ciscoipphone|ciscosoftphone>
Chapter 53 Using Automatic QoS
OL-8978-04