Reverting To The Qos Defaults; Disabling Qos; Configuring Cops Support - Cisco WS-C6506 Software Manual

Chapter 52 Configuring QoS

Reverting to the QoS Defaults

Note Reverting to the defaults disables QoS, because QoS is disabled by default.
To revert to the QoS defaults, perform this task in privileged mode:
Task
Revert to the QoS defaults.
This example shows how to revert to the QoS defaults:
Console> (enable) clear qos config
This command will disable QoS and take values back to factory default.
Do you want to continue (y/n) [n]? y
QoS config cleared.
Console> (enable)

Disabling QoS

To disable QoS, perform this task in privileged mode:
Task
Disable QoS on the switch.
This example shows how to disable QoS:
Console> (enable) set qos disable
QoS is disabled.
Console> (enable)

Configuring COPS Support

Note •
•
•
These sections describe configuring COPS support:
•
•
•
OL-8978-04
Supervisor Engine 1 with a Layer 2 Switching Engine does not support the commands in this
section.
COPS can configure QoS only for the IP traffic. Use the CLI or SNMP to configure QoS for all the
other traffic.
Throughout this publication and all Catalyst 6500 series publications, the term COPS refers to
COPS support as implemented on the Catalyst 6500 series switches.
Port ASICs, page 52-80
Understanding QoS Policy, page 52-80
Selecting COPS as the QoS Policy Source, page 52-80
Command
clear qos config
Command
set qos {enable | disable}
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring QoS on the Switch
52-79