Cisco WS-C6506 Software Manual page 485

Chapter 15 Configuring Access Control
To enable the automatic execution of the CRAM feature, perform this task in privileged mode:
Task
Enable the automatic execution of the
CRAM feature.
These examples show how to enable the automatic execution of the CRAM feature:
Console> (enable) set security acl cram auto
Cram auto mode enabled. Timer is default =
Console> (enable)
Console> (enable) set security acl cram auto 1000
Cram auto mode enabled. Timer is 1000 seconds
Console> (enable)
Displaying the CRAM Feature Status Information
Enter the show security acl cram command to display the CRAM feature status information.
To display the CRAM feature status information, perform this task in normal mode:
Task
Display the CRAM feature status
information.
This example shows how to display the CRAM feature status information:
Console> (enable) show security acl cram
Cram auto mode is enabled. Timer is 300.
Cram last run on Fri Jun 18 2004, 10:06:29
Security ACL mask usage before: 0.17%
Security ACL mask usage after: 0.12%
Total number of cram executions = 2
Console> (enable)
Disabling the CRAM Feature Automatic Mode
Enter the clear security acl cram auto command to disable the CRAM automatic mode.
To disable the CRAM automatic mode, perform this task in privileged mode:
Task
Disable the CRAM automatic mode.
This example shows how to disable the CRAM automatic mode:
Console> (enable) clear security acl cram auto
Cram auto mode disabled.
Console> (enable)
OL-8978-04
Configuring the Compression and Reordering of ACL Masks
Command
set security acl cram auto [nsec]
300 seconds
Command
show security acl cram
Command
clear security acl cram auto
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
15-89