Cisco WS-C6506 Software Manual page 993

Chapter 39 Configuring the Switch Access Using AAA
Figure 39-5
TACACS+
server
172.20.52.10
Workstation A
In this example, TACACS+ accounting is enabled for connection, EXEC, system, and all command
accounting:
Console> (enable) set accounting connect enable stop-only tacacs+
Accounting set to enable for connect events in stop-only mode.
Console> (enable) set accounting exec enable stop-only tacacs+
Accounting set to enable for exec events in stop-only mode.
Console> (enable) set accounting commands enable all stop-only tacacs+
Accounting set to enable for commands-all events in stop-only mode.
Console> (enable) set accounting update periodic 120
Accounting updates will be periodic at 120 minute intervals.
Console> (enable) show accounting
Event
-----
exec:
connect:
system:
commands:
config:
all:
TACACS+ Suppress for no username: enabled
Update Frequency: periodic, Interval = 120
Accounting information:
-----------------------
Active Accounted actions on tty0, User (null) Priv 0
Active Accounted actions on tty288091924, User (null) Priv 0
Overall Accounting Traffic:
Exec
Connect
Command
System
Console> (enable)
OL-8978-04
TACACS+ Example Network Topology
Switch
Console port
connection
Terminal
Method Mode
------- ----
tacacs+ stop-only
tacacs+ stop-only
tacacs+ stop-only
- -
tacacs+ stop-only
Starts Stops Active
----- ----- ------
0 0 0
0 0 0
0 0 0
1 0 0
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Configuring Accounting on the Switch
39-59