Setting Transceiver Monitoring And Thresholds - Cisco WS-C6506 Software Manual

Chapter 20 Checking Status and Connectivity

Setting Transceiver Monitoring and Thresholds

The following sections describe how to set transceiver monitoring parameters and thresholds:
•
•
•
Enabling or Disabling Transceiver Monitoring
To enable or disable transceiver monitoring, perform this task in enabled mode:
Task
Enable transceiver monitoring.
This example shows how to enable transceiver monitoring:
Console> (enable) set transceiver-monitoring enable
Transceiver monitoring is successfully enabled
This example shows how to disable transceiver monitoring:
Console> (enable) set transceiver-monitoring disable
Transceiver monitoring is successfully disabled
Setting the Transceiver Monitoring Interval
To set the transceiver monitoring interval, perform this task in enabled mode:
Task
Set the transceiver monitoring interval.
This example shows how to set the transceiver monitoring interval:
Console> (enable) set transceiver-monitoring interval 10
Transceiver monitoring interval is set to 10 minutes
Setting the Transceiver Temperature Threshold
To set a transceiver temperature threshold, perform this task in enabled mode:
Task
Set a transceiver temperature threshold.
This example shows how to set a transceiver temperature threshold without specifying the severity:
OL-8978-04
Enabling or Disabling Transceiver Monitoring, page 20-77
Setting the Transceiver Monitoring Interval, page 20-77
Setting the Transceiver Temperature Threshold, page 20-77
Command
set transceiver-monitoring [enable | disable]
Command
set transceiver-monitoring interval minutes
Command
set port transceiver mod/port [current | rx-power
| temperature | tx-power | voltage] [high-alarm |
high-warn | low-alarm | low-warn] severity
severity value
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
Digital Optical Monitoring
20-77