Cisco WS-C6506 Software Manual page 1136

Configuring and Monitoring the Integrated Switch Fabric and Switch Fabric Module on the Switch
Displaying the Backplane Traffic and Fabric Channel Input and Output
To display the backplane traffic and fabric channel input and output, perform either of these tasks:
Task
Display the system status including the backplane
traffic and fabric channel input and output.
Display the backplane traffic and fabric channel
input and output.
Supervisor Engine 720 with PFC3A does not support a hardware traffic meter. When you enter the show
Note
system and show traffic commands on this module, you do not receive backplane traffic information.
This example shows how to display the system status including backplane traffic and fabric channel
input and output:
Console> (enable) show system
PS1-Status PS2-Status
---------- ----------
ok
Fan-Status Temp-Alarm Sys-Status Uptime d,h:m:s Logout
---------- ---------- ---------- -------------- ---------
ok
PS1-Type
-------------------- --------------------
WS-CAC-1300W
Modem
------- ----- ----------------- ---- ------------------------
disable
PS1 Capacity: 1153.32 Watts (27.46 Amps @42V)
System Name
------------------------ ------------------------ ------------------------ ---
Slot Channel Fab Chan Input Output
---- ------- -------- ----- ------
Core Dump
------------------------ -------------------------------------------
disabled
Crash Info
------------------------ -------------------------------------------
enabled
System Information Logging
--------------------------
Disabled
System Information Log File
----------------------------------------------------------------------
Catalyst 6500 Series Switch Software Configuration Guide—Release 8.7
46-10
none
off ok
PS2-Type
none
Baud Backplane-Traffic Peak Peak-Time
9600 0%
System Location
2 0 1 0%
Core File
slot0:crashdump
Crash Info File
bootflash:crashinfo
Command
show system
show traffic
13,19:01:16 20 min
0% Tue Oct 19 2004, 12:04:18
0%
Host Interval
---------------- --------
- 1440
Chapter 46 Configuring the Switch Fabric Modules
System Contact CC
OL-8978-04