Mlx-5 And Mlx-5D Telephones - Lucent Technologies MERLIN LEGEND Release 5.0 System Planning Manual

MERLIN LEGEND Communications System Release 5.0
System Planning 555-650-112
New Features and Enhancements
Release 5.0 Enhancements
If all three thresholds are set to the same value, the result is one threshold only
with LED state either off or on (steady). If two values are the same, then the result
is two alarm levels (flash, steady). The factory setting is one call for all three
thresholds with LED states of off and steady.
An external alert only signals when the number of calls in the queue meets or
exceeds the programmed Threshold 3 value.

MLX-5 and MLX-5D Telephones

The MLX-5 nondisplay and MLX-5D display telephones are compatible with all
system releases. The display telephone includes a 2-line by 24-character display,
and both telephones come with 5 line buttons. In systems prior to Release 5.0, the
MLX-5 and MLX-5D telephones are treated as MLX-10 and MLX-10D telephones
respectively. As of Release 5.0, the system recognizes the MLX-5 and MLX-5D
telephones as 5-button telephones.
If these telephones are connected to communications system releases prior to 5.0
they are recognized by the communications system as 10 button telephones.
NOTE:
A DSS (Direct Station Selector) button that is used as a
Calls-in-Queue Alarm button can only indicate two threshold levels,
either by flashing or by lighting steadily. If a calling group must use
this type of Calls-in-Queue Alarm button, only two threshold levels
should be programmed.
0
Issue 1
June 1997
Page xxii