Upgrading The System - Lucent Technologies MERLIN LEGEND Release 5.0 System Programming And Maintenance Manual

MERLIN LEGEND Communications System Release 5.0
System Programming and Maintenance (SPM) 555-650-140
System Programming and Maintenance

Upgrading the System

To save to the filename of your choice, type [ filename ] and press
To print the reports to the hard disk if the print file already exists, use the arrow
keys to highlight the [ filename ] and press
Print to Floppy Disk
Use the arrow keys to highlight
the methods shown below.
To print the reports to a floppy disk if the print file does not exist, use the
arrow keys to highlight
— To save to the default print filename (
— To save to the filename of your choice, type [ filename ] and press
To print the reports to a floppy disk if the print file already exists, use the
arrow keys to highlight the [ filename ] and press
Upgrading the System
!
!
WARNING:
The following procedures are to be used by qualified technicians or service
personnel only. Installation or maintenance of this product by anyone other
than qualified personnel may damage or impair the product; your limited
warranty does not cover such damage. For details, see your limited
warranty in the Customer Support Information in the back of this book.
Hazardous electrical voltages are present inside this product.
This section describes upgrading your communications system to Release 5.0.
You can use this procedure to perform the following upgrades:
From Release 1.0 to Release 5.0
From Release 1.1 to Release 5.0
MAKE NEW FILE
.
P
.
P
and press
GOTO FLOPPY:
and press
. Use one of
P
.
P
), press
print.ams
.
P
Issue 1
June 1997
Page 69
.
P
.
P