Igmp Snooping Multicast (Ism) Vlan Commands - D-Link xStack DGS-3400 Series Reference Manual

xStack
The IGMP Snooping Multicast (ISM) VLAN commands in the Command Line Interface (CLI) are listed (along with the
appropriate parameters) in the following table.
Command
create igmp_snooping multicast_vlan
config igmp_snooping multicast_vlan
config igmp_snooping
multicast_vlan_group
show igmp_snooping
multicast_vlan_group
delete igmp_snooping multicast_vlan
show igmp_snooping multicast_vlan
Each command is listed, in detail, in the following sections.
create igmp_snooping multicast_vlan
Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
®
DGS-3400 Series Layer 2 Gigabit Ethernet Managed Switch CLI Manual
IGMP S
NOOPING
Parameters
<vlan_name 32> <vlanid 2-4094> { remap_priority [ <value 0-7> | none ] {
replace_priority } }
<vlan_name 32> {member_port <portlist> | [source_port <portlist> |
untag_source_port <portlist>] | tag_member_port <portlist> | state [enable |
disable] | replace_source_ip <ipaddr> | remap_priority[<value 0-7> | none]
{replace_priority}}
<vlan_name 32> [add <mcast_address_list> | delete <mcast_address_list> |
delete_all]
{< vlan_name 32> }
<vlan_name 32>
{<vlan_name 32>}
Used to create a multicast VLAN.
create igmp_snooping multicast_vlan <vlan_name 32> <vlanid 2-4094> {
remap_priority [ <value 0-7> | none ] { replace_priority } }
The create igmp_snooping command creates a multicast VLAN and implements relevant
parameters as specified. More than one multicast VLANs can be configured. The maximum
number of configurable VLANs is project dependent.
Newly created IGMP snooping must use a unique VLAN ID and name, i.e. they cannot use
the VLAN ID or name of any existing 802.1q VLAN.
Also keep in mind the following conditions:
•
Multicast VLANs cannot be configured or displayed using 802.1Q VLAN commands.
•
An IP interface cannot be bound to a multicast VLAN.
•
The multicast VLAN snooping function co-exists with the 802.1q VLAN snooping
function.
vlan_name - The name of the multicast VLAN to be created. Each multicast VLAN is given a
name that can be up to 32 characters.
vlanid - The VLAN ID of the multicast VLAN to be created. The range is 2 - 4094.
remap_priority - The remap priority (0 to 7) to be associated with the data traffic to be
forwarded on the multicast VLAN. If none is specified, the packet's original priority will be
used. The default setting is none.
replace_priority - Specify that packet's priority will be changed by the switch, based on the
remap priority. This flag will only take effect when the remap priority is set.
Only Administrator and Operator-level users can issue this command.
M (ISM) VLAN C
ULTICAST
426
55
OMMANDS