Debug Commands; Show Commands - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

JUNOSe 11.0.x IP, IPv6, and IGP Configuration Guide

debug Commands

The debug commands provide information about the following RIP items:
debug ip rip
undebug ip rip

show Commands

Use the show commands to monitor the following types of RIP information:
230
Monitoring RIP
General events, such as creating a RIP process or removing RIP from an interface
Routing events, such as when two RIP routers exchange routes
Use to display information about selected RIP events. This command has many
keywords that allow you to specify a variety of RIP events.
You can set the level of severity for the events you want displayed; specify the
desired descriptive term or a corresponding number (0–7).
You can set the verbosity of the messages you want displayed: low, medium,
high.
Example
host1#debug ip rip events
Use the no version to cancel the display of any information about the designated
variable.
See debug ip rip
Use to cancel the display of information about a selected event.
The same RIP variables can be designated as in the debug ip rip command.
Example
host1#undebug ip rip events
There is no no version.
See undebug ip rip
Configuration
IP-related information
Global counters
Counters for a specified network
Statistics