References; Before You Configure Ipv6 - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

References

For more information about IPv6, consult the following resources:
You can access these and other Internet RFCs and drafts at the following URL:
http://www.ietf.org

Before You Configure IPv6

Before you configure IPv6, you must create the lower-layer interfaces over which
IPv6 traffic flows. In this release, the following modules support IPv6 configuration:
For example, to configure an ATM interface:
See E120 and E320 Module Guide, Appendix A, IOA Protocol Support for information
about the modules that support IP.
RFC 2373 IP Version 6 Addressing Architecture (July 1998)
RFC 2460 Internet Protocol, Version 6 (IPv6) (December 1998)
RFC 2461 Neighbor Discovery for IP Version 6 (IPv6) (December 1998)
RFC 2462 IPv6 Stateless Address Autoconfiguration (December 1998)
RFC 2463 Internet Control Message Protocol (ICMPv6) for the Internet Protocol
Version 6 (IPv6) Specification (December 1998)
RFC 2464 Transmission of IPv6 Packets over Ethernet Networks (December
1998)
RFC 2465 Management Information Base for IP Version 6: Textual Conventions
and General Group (December 1998)
RFC 2466 Management Information Base for IP Version 6: ICMPv6 Group
(December 1998)
ATM OC3/STM-1
ATM OC12/STM-4
Fast Ethernet (FE-8)
Gigabit Ethernet (GE)
10-Gigabit Ethernet (10GE)
OC48 POS (PPP only)
host1(config)#interface atm 1/0
host1(config-if)#atm sonet stm-1
host1(config-if)#no loopback
host1(config-if)#atm clock internal chassis
host1(config-if)#interface atm 1/0.10
host1(config-if)#atm pvc 10 0 20 aal5snap
Chapter 2: Configuring IPv6
133
References