Ip Show Commands - Juniper IGP - CONFIGURATION GUIDE V11.1.X Configuration Manual

baseline tcp

IP show Commands

You can monitor the following aspects of IP using show ip commands:
There is no no version.
See baseline ip udp
Use to set a statistics baseline for all (both IPv4 and IPv6) TCP statistics or for
only IPv4 or IPv6 statistics.
The router implements the baseline by reading and storing the statistics at the
time the baseline is set and then subtracting this baseline whenever
baseline-relative statistics are retrieved.
Use the ip keyword to implement a baseline for only IPv4 statistics.
Use the delta keyword with IP show commands to specify that baselined statistics
are to be shown.
Example 1
host1#baseline tcp
Example 2
host1#baseline ip tcp
There is no no version.
See baseline tcp
To Display
Access lists
ARP
General IP information
IP addresses
Community lists
Routing table
Interfaces
Shared IP interfaces
Command
"show access-list" on page 82
"show ip as-path-access-list" on page 86
"show arp" on page 83
"show ip" on page 84
"show ip address" on page 84
"show ip community-list" on page 87
"show ip forwarding-table slot" on page 87
show forwarding-table route-holddown in JUNOSe Command
Reference Guide
"show ip interface" on page 88
"show ip interface shares" on page 93
Chapter 1: Configuring IP
81
Monitoring IP