JunosE 11.3.x Multicast Routing Configuration Guide
Establishing the IGMP Proxy Baseline
baseline ip igmp-proxy interface
Monitoring IGMP Proxy
show ip igmp-proxy
74
You can set the counters for the number of queries received and reports sent on the
upstream interface to zero. This feature enables you to establish a reference point, or
baseline, for IGMP proxy statistics.
Use to set the counters for the number of queries received and reports sent on the
upstream interface to zero.
NOTE: Issue this command only on the upstream interface. Otherwise, this
command has no effect.
Example
(host1)#baseline ip igmp-proxy interface
There is no no version.
See baseline ip igmp-proxy interface.
To display IGMP proxy parameters, use the following show commands.
Use to display IGMP proxy parameters for a VR.
Field descriptions
Routing Process—IGMP proxy protocol
Administrative state—State of IGMP proxy in the software: enabled or disabled
Operational state—Operational state of IGMP proxy: enabled or disabled
total interface—Number of IGMP proxy interfaces on the VR; currently only one
upstream interface per VR
state—Operational state of the IGMP proxy interfaces: enabled or disabled
multicast group—Number of multicast groups associated with IGMP proxy interfaces
Example
host1#show ip igmp-proxy
Routing Process IGMP Proxy, Administrative state enabled, Operational
state enabled
total 1 upstream interface, state enabled
6 multicast group
Copyright © 2010, Juniper Networks, Inc.