Displaying Monitor Link Configuration; Monitor Link Configuration Example; Implementing Collaboration Between Smart Link And Monitor Link - H3C S5100-SI Operation Manual

Displaying Monitor Link Configuration

To do...
Display the information about
one or all monitor link groups

Monitor Link Configuration Example

Implementing Collaboration Between Smart Link and Monitor Link

Network requirements
As shown in Figure
Link and Monitor Link to prevent the PCs from failing to access the server and Internet due to uplink link
or port failure.
Network diagram
Figure 2-3 Network diagram for Monitor Link configuration
GE1/0/10
Switch C GE1/0/1
GE1/0/2
GE1/0/3
GE1/0/1
GE1/0/2
Switch A
PC 1 PC 2
Configuration procedure
1) Enable Smart Link on Switch A and Switch B to implement link redundancy backup. Perform the
following configuration on Switch A. The configuration on Switch B is the same as on Switch A.
# Enter system view.
<switchA> system-view
# Enter Ethernet port view. Disable STP on GigabitEthernet1/0/1 and GigabitEthernet1/0/2.
[SwitchA] interface GigabitEthernet 1/0/1
Use the command...
display monitor-link group
{ group-id | all }
2-3, the PCs access the server and Internet through the switch. Configure Smart
Server
GE1/0/11
Switch E
GE1/0/1 Switch D
GE1/0/2
GE1/0/3
BLOCK GE1/0/1
GE1/0/2
Switch B
PC 3 PC 4
Available in any view.
2-5
Remarks