Displaying And Maintaining Ipv6 Static Routes; Ipv6 Static Routing Configuration Example - H3C S5120-HI Series Configuration Manual

To do...
Configure an IPv6 static route
NOTE:
If you specify a broadcast interface, such as a VLAN interface, as the output interface for a static
route, you must specify the next hop address.

Displaying and maintaining IPv6 static routes

To do...
Display IPv6 static route
information
Remove all IPv6 static routes
NOTE:
Using the undo ipv6 route-static command can delete a single IPv6 static route. Using the
•
delete ipv6 static-routes all command deletes all IPv6 static routes including the default route.
For more information about the display ipv6 routing-table protocol static [ inactive | verbose ]
•
[ | { begin | exclude | include }
Command Reference

IPv6 static routing configuration example

Network requirements
As shown in
.
Figure 2, configure IPv6 static routes so that hosts can reach one another.
Use the commands...
ipv6 route-static ipv6-address prefix-length
{ interface-type interface-number
[ next-hop-address ] | next-hop-address }
[ preference preference-value ]
Use the command...
display ipv6 routing-table protocol
static [ inactive | verbose ] [ |
{ begin | exclude | include }
regular-expression ]
delete ipv6 static-routes all
regular-expression
10
Remarks
Required
The default
preference of IPv6
static routes is 60.
Remarks
Available in any view
Available in system view
Layer 3—IP Routing
] command, see