Displaying Arp Table Size Configuration; Arp Table Size Configuration Example - H3C S9500 Series Operation Manual

Operation Manual – ARP
H3C S9500 Series Routing Switches
Configure the maximum
number of aggregation
ARP entries supported by
a card
Configure the maximum
number of ARP entries
supported by the switch
To remove the configurations, use the corresponding undo commands.
Caution:
Restart the system to make the above configurations effective.
After the above configurations, do not change cards or slots before you restart the
system. Otherwise, the configurations may fail to take effect.
After the above configurations, do not perform active/standby switchover before you
restart the system. Otherwise, the configurations will not take effect even if you
restart the system.

2.3 Displaying ARP Table Size Configuration

Display the maximum numbers
of current ARP entries and
entries that will take effect after
the switch restarts

2.4 ARP Table Size Configuration Example

I. Network requirements
A host is connected to an S9500 series routing switch. The model names of all the
cards in the switch system are suffixed with C, CA, or CB.
To do...
arp
max-aggregation-entry
max-aggnum
arp enable size { 4 | 64 }
To do...
Chapter 2 ARP Table Size Configuration
Use the command...
Use the command...
display arp max-entry
2-3
Remarks
The maximum number of
aggregation ARP entries
supported by a card is 1K
by default.
The maximum number of
ARP entries supported by
the whole switch is 4K by
default.
Remarks
Available in any
view