Table of Contents
Advertisement
4 Configuration
The fields that can be configured f are described below:
Item
Link Aggregation Global Settings
Link Aggregation
Channel Group Information
ID
Port
Click Apply to make the configurations take effect.
Click Delete to remove the Link Aggregation group.
L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Settings
With Internet Group Management Protocol (IGMP) snooping, the Smart Managed Switch can make
intelligent multicast forwarding decisions by examining the contents of each frame's Layer 2 MAC header.
By default, IGMP is disabled. If enabled, the Smart Managed Switch can recognize IGMP queries and
reports sent between network stations or devices and an IGMP host. With IGMP snooping enabled, the
Smart Managed Switch will forward multicast traffic only to the connections that requested it.
Figure 4.46 - L2 Features > L2 Multicast Control > IGMP Snooping > IGMP Snooping Settings
The fields that can be configured for are described below:
Item
IGMP Snooping
Figure 4.45 - L2 Features > Link Aggregation
Description
Specify to enable or disable the Link Aggregation function.
Select a link aggregation group.
Select the ports to assign to the aggregation group.
Table 4.26
NOTE: Each combined port must be connected
to devices within the same VLAN group.
Description
Specify to enable or disable the IGMP Snooping function of the
Switch.
Table 4.27
3
3
3
3
D-Link Smart Managed Switch User Manual
Advertisement
Table of Contents
