Configuring The Time Code Operating Modes; How To Set The Video Generator Time - evertz 4025TR Instruction Manual

!
OPERATION
3.9.2

Configuring the Time Code Operating Modes

Use the Codes and Outputs tabs of the configuration screen to configure the
time code modes.
Selection of the desired mode of operation for the generator is performed
using the setup menu displayed on the character generator. Press the
SETUP key to access the setup menu. Using the " & # keys drop down
the TIMECODE menu. Use the $ & % keys to highlight the GEN ASSIGN
menu item and press the SELECT key to show the generator operational
modes sub menu. The currently programmed generator assignment mode
is shown in reverse video. Press the $ & % keys one or more times to
select the desired mode of operation. Press the SETUP or CLR keys to
exit the setup menu, or press the SELECT key to return to the TIMECODE
drop down menu. (See section 3.3.1 and Figure 3-10 and Figure 3-11 for
more information about the various time code modes).
3.9.3

How to Set the Video Generator Time

Use the Set Codes window to manually enter timecodes.
When entering time data make sure that the Video generator is not in one
of the JAM modes (indicated when the JAM LED is on). If it is use the
setup menu as described above to select one of the RUN or CINE time
modes. Press the VID TC key to display the Video logical generator time.
Press the TIME / UB key to display the Video generator time if it is not
already displayed. The ENTER and CLR keys are used in conjunction with
the numeric keys to set the generator time.
The telecine must be stopped before you attempt to set the Video generator
time.
Press the ENTER key to recall the last time that you entered into the
generator. The display prompt at the left of the display will blink while data
entry mode is active, and the dual functioned keys are now changed to
their numeric values. If you want to re-enter this time press the ENTER
key to complete the data entry into the generator time.
Pressing any numeric key will clear the previous value and place the new
value into the numeric display, starting at the right. Unentered digits are
assumed to be zero, hence leading zero digits are not required. When the
Model 4025TR Film Footage Encoder Manual
Page 3-38