Setup Menu - Overview - evertz 4025TR Instruction Manual

3.2 SETUP MENU - OVERVIEW

OPERATION
PULL NTSC: Indicates that the telecine is set to transfer for a 24 film
frame per second transfer to NTSC video.
Setting the transfer rate is accomplished by using FILM RATE
item on the FILM pulldown menu. The 4025TR may be set to
either 24 or 30 FPS transfer rates, or may be set to
automatically detect the transfer rate in use by the telecine.
(See section 3.10.10)
PAL: This LED should always be Off, as the transfer rate is
always set to 25 FPS.
The key to the operational flexibility of the 4025TR Film Footage Encoder
lies in the powerful setup menu system. The setup menu uses the built in
character generator and provides a quick, intuitive method of configuring
4025TR Film Footage Encoder, guiding you to the correct setup for your
application. The six keys in the Setup key group (SETUP, SELECT " #
$ %) are used to cycle through the various items on the programming
menu.
The setup menu should only be used to configure the 4025TR for local mode
operation. Under normal operation the 4025TR will be configured using the
K L TRACKER™ software. When the 4025TR is put into remote mode,
EY OG
the K L TRACKER™ software will prompt the user to re-apply the
EY OG
configuration, so that the computer and hardware are using the same
configuration settings.
The 4025TR menu system consists of three drop down menus. The titles
of each of the drop down menus are shown on the top line of the character
display. Selecting an item on one of the drop down menus reveals a sub-
menu showing the choices for that item. Figure 3-8 is an overview of the
on screen menu system, and shows all the menu choices and where you
will find the menu items. Note that some menu choices will be hidden
depending on the programmed mode of operation.
The TIMECODE drop down menu is for overall operation modes such as
selecting which information is put into the LTC and VITC generators,
setting reader modes, setting VITC line numbers, etc. The FILM drop
down menu is used to set up specific film number modes such as KeyKode
Jam, film type, film transfer rate, etc. The CONFIG drop down menu is
used to configure miscellaneous items such as video standard, character
size and style, KeyKode head offset, video path delays, etc.
Model 4025TR Film Footage Encoder Manual
Page 3-8