An Overview Of The Status Indicators - evertz 4025TR Instruction Manual

!
OPERATION
3.1.6

An Overview of the Status Indicators

There are 15 status indicators located on the front panel, which show
operational status of the 4025TR at a glance.
PAL GEN-LOCK
PAL video reference. If it is blinking, it indicates that the PAL
video standard is selected, but a valid PAL video reference is
not present.
NTSC GEN-LOCK
NTSC video reference.
NTSC video standard is selected, but a valid NTSC video
reference is not present.
FRAME Indicates that the 4025TR has detected the presence of a valid
film frame pulse from the telecine. If the 4025TR is not set for
the same video standard and film transfer rate as the incoming
film frame pulse, this LED will be Off.
LOCK Indicates that the telecine has achieved a stable play speed and
that the 4025TR is properly locked to the telecine's transfer
sequence.
To ensure proper operation of the 4025TR, the GEN-LOCK, FRAME & LOCK
indicators MUST be solidly on during the film to tape transfer.
COMM Indicates that the 4025TR is sending data to a computer
running the K
the K
data to the computer.
DLO Indicates that a data log event packet has been sent to the
K
EY
Model 4025TR Film Footage Encoder Manual
FI LM
T I E M U B
OPEN
P AL
G E - N
Figure 3-5: System Status Indicators
Indicates that the unit is properly gen locked to a
Indicates that the unit is properly gen-locked to a
L TRACKER™ software. In certain modes of
EY OG
L TRACKER™ software, the 4025 will stop sending
EY OG
L TRACKER™ software.
OG
F O O T G A E E N C O E D
N TSC FRA M E LOCK COMM DLO
L OCK TE L E INE C TRACKER
If it is blinking, it indicates that the
Page 3-6