Acmade Number Entry -Using The Keykode Register - evertz 4025TR Instruction Manual

!
OPERATION
emulsion code table Figure 9-1 for a list of the film emulsions currently
supported)
When you have selected the correct film type, press the ENTER key to
proceed to the numeric prefix entry. The leftmost digits of the display will
indicate PREFIX and the dual functioned keys assume their numeric
values. Pressing any numeric key will place the new value into the display,
starting at the right. Leading blank digits are assumed to be zero. When
the required number of digits of prefix are entered, press the ENTER key to
complete the edge number prefix entry.
Attempts to enter too many digits will result in clearing of the display. Re-
enter the correct value and press the ENTER key. Pressing the CLR key
will cancel the prefix entry mode without changing any data.
The numeric keys return to their normal functions, and the prefix message
stops blinking when the data entry has been completed by pressing the
ENTER key or cancelled by pressing the CLR key.
Prefix entry mode must be terminated (the prefix message will stop blinking)
before any of the front panel keys will resume their normal operation.
3.10.4 ACMADE Number Entry –using the KeyKode Register
When using Ink numbers from the KeyLog TRACKER™ software use the Ink
number generator NOT the KeyKode Generator. The Ink numbers can be set
using the Set Codes window. The Ink numbers can be inserted into the VITC
by setting the VITC2 pulldown, on the Outputs tab of the configuration
screen, to the Ink Number generator.
When KeyKode Jam is turned off, the 4025TR logical KeyKode generator
may be used to hold ACMADE Ink numbers in place of the KeyKode
numbers. They are also encoded into the timecode and Data log outputs in
place of the KeyKode numbers.
windows of the Ink numbers use the Ink number logical generator. See
section 3.10.5.
To enter the footage and frames part of the number follow the procedure
outlined in the manual section 3.10.2.
number follow the procedure outlined in section 3.10.3 above.
manufacturer code '99' that is represented by letter code 'I'. For the film
types, you may select any of the permitted ACMADE letter suffixes as
shown in Figure 3-12. For the numeric part of the prefix you are permitted
a 3 digit number only.
Model 4025TR Film Footage Encoder Manual
If you only need to make character
To enter the prefix part of the
Select
Page 3-48