Table of Contents
Advertisement
4015
!
2.2 INSIDE THE 4025TR: REMOVING THE FRONT PANEL
INSTALLATION
2.1.4 Character Generator Connectors
Figure 2-4: Character Generator Rear Panel Connections
IN:
A BNC loop for input of program video onto which characters
are to be inserted. This signal is required for proper gen-locking
of Model 4025TR Character Generator.
configured to operate as a terminated input, providing a second
output of the character generator on the connector labeled B.
OUT:
A BNC output of program video with characters inserted. This
output is also used to display the Setup menu system.
2.1.5
Serial I/O Connections
SERIAL I/O: A 9 pin female 'D' connector for connection to a computer for
logging the timecode / KeyKode relationships to a data logging
utility such as Key-Log
AUX I/O: A 9-pin female 'D' connector for connection to an external
KeyKode Reader.
2.1.6
Power Connections
LINE:
The 4025TR may be set for either 115v/60 Hz or 230v/50 Hz AC
operation. The voltage selector switch is accessible on the rear
panel.
The line voltage connector contains an integral slow
blow fuse (and a spare one). (See section 2.4 for power and
fuse specifications).
During the installation procedure it may be necessary to remove the front
panel to gain access to the programming switches located inside the
4025TR. You can accomplish this in a few seconds by turning the quick
release fasteners, located at the left and right hand sides of the front panel,
several turns counter clockwise.
showing the three circuit modules that comprise the 4025TR. The front
panel assembly should be placed on the workbench, and should not be left
suspended by the ribbon cable, as this may cause damage.
Model 4025TR Film Footage Encoder Manual
The front panel assembly pulls off
The loop may be
Page 2-3
Advertisement
Table of Contents
