First Time Set-Up; Connecting The Evertz Reader Head To The Digisync Console; Connecting The Digisync Console To The 4025Tr Film Footage Encoder - evertz 4025TR Instruction Manual

8.3 CONNECTING THE EVERTZ READER HEAD TO THE DIGISYNC CONSOLE

KEYKODE READER INSTALLATION
8.2.4

First Time Set-Up

After applying power to the 5500, check to make sure that you are using
the correct sensor for the film type you are using by pressing the MODE
key. The active sensor will be shown in the front panel display.
SENSOR =35mm
SENSOR =35mm REV
SENSOR =16mm
To select a different sensor, press the SHIFT + MODE keys until the
desired sensor is displayed.
normal KeyKode display.
In addition you need to select whether you are reading from negative or
print film stock. This is accomplished using the SETUP menu. To enter
the front panel SETUP menus, press the SETUP key. Press the down
arrow key (!) until you have selected the type menu item. If the film type
is incorrect, press the " key to select other film type. When you have
made the desired change, press the SETUP key to return to the normal
display mode. See section 3.1.4 of the 5500 manual for more information
about the SETUP menu system.
A 12 foot long cable is supplied to connect the reader head to the DigiSync
console. If you wish to mount the console more than 12 feet from the
telecine, 50 foot extender cable may be purchased. The console may be
located up to a maximum distance of 100 feet from the reader head. Plug
the cable into the connector on the reader head. (It is usually easier to
connect the cable prior to mounting the head on the bracket.) Connect the
other end of the cable to the DigiSync console. Refer to section 3 of the
DigiSync manual for further information on connecting the reader head to
the DigiSync console.
8.3.1 Connecting the DigiSync console to the 4025TR Film Footage
Encoder
A 9 pin D connector on the rear of the DigiSync console provides RS-232
serial data communications with the 4025TR. Use the cable supplied (Part
No. WA-C67) or wire a longer cable if required. Wiring information for the
DigiSync to 4025TR cable is as shown in section 7.2.1.
suggested length of this cable is 50 feet, although longer cables may be
used if the wire size is made larger. Care should be taken to ensure that
shielded cable is used, and that the shield is connected through.
Model 4025TR Film Footage Encoder Manual
lower 35mm KeyKode sensor is active
upper 35mm KeyKode sensor is active
(this is used when the film was rewound before
loading it into the camera)
16mm KeyKode sensor is active
Press the DISPLAY key to return to the
Maximum
Page 8-6