evertz 4025TR Instruction Manual page 45

"
INSTALLATION
Figure 2-10: Cintel Frame Pulse Specification
Connection of a Film frame pulse is required even with PAL video to permit
the 4025TR to distinguish the difference between the field 1 and field 2
dominant pull downs.
It is essential that the 4025TR be connected to the correct FILM FRAME
pulse from the telecine. Generally this pulse is labelled "FRAME PULSE"
on the Cintel Telecines and is found on the rear of the Digiscan electronics
rack. Figure 2-10 shows some specifications of the expected Frame Pulse
into the 4025TR. This should allow you to locate the appropriate signal,
regardless of the labelling on your telecine. The Cintel telecine manuals or
technical support personnel may also be able to assist you.
The telecine type item of the Engineering toolbox hardware menu controls
whether standard Cintel, URSA Gold or Philips pulldown pulse is expected.
The telecine type should be set to the MKIII/DIGI IV or URSA Diamond
settings accordingly to accept the Cintel style FRAME pulse input from the
"FRAME BNC connector on rear panel. (See section 3.6.4)
If the right hand LED on the 615 module (center card behind the front
panel) is blinking, or dim, or flickering rapidly, that is an indication that the
Frame Pulse input is not satisfactory.
Model 4025TR Film Footage Encoder Manual
Page 2-17