Table of Contents
Advertisement
5.2 632 HELP MESSAGES
SYSTEM DIAGNOSTICS
5.1.7
KeyKode Reader Communications Problems
SERIAL: FRAMING/OVERRUN ERR
SERIAL: PARITY ERROR
SERIAL: RECEIVE TIMEOUT 1
SERIAL: RECEIVE TIMEOUT 2
SERIAL: UNIDENTIFIED CMD
SERIAL: J-RECORD ENDING ERR
5.1.8
ARRI Timecode Problems
ARRI JAM: TIME DIFFERS
ARRI JAM: UB DIFFERS
ARRI CODE OFF
ARRI CODE MISSING
ARRI CODE INVALID
5.2.1
General Messages
NO NEW PROBLEMS
GENLOCK MISSING
NOVRAM 1ST BIRTHDAY
EVCOM RESET
STACK RESET
HARDWARE /SOFTWARE MISMATCH
VIDEO STD SWITCH PROBLEM
Model 4025TR Film Footage Encoder Manual
Indicate problems with the serial input data from
the KEYKODE reader. These include
parity/baud problems and message format
problems.
Usually indicates DigiSync console set to Welch
Allyn Mod protocol. Set DigiSync to Welch Allyn
protocol (See manual section 8.3.2).
Indicates why the ARRI code re-jammed the
Audio time code numbers.
Indicates the ARRI code Jam has been turned
OFF.
Biphase is indicating that the telecine is in motion
but no ARRI code is being received.
An illegal or invalid ARRI code combination has
been selected. Usually this message is replaced
by more specific messages.
Indicates the 632 message has been reset and
no further problems have been detected.
The CHAR GEN IN video input is missing or
disturbed.
The Non-volatile memory has been reset to
factory defaults.
An inter-module communications reset occurred,
usually caused by a power on reset of one or all
the cards.
The 632 needed to do some software error
prevention - please call us if you get this
message.
The 615 has detected the firmware is
incompatible with the hardware.
The 615 was unable to switch video standards.
Page 5-5
Advertisement
Table of Contents
