Table of Contents
Advertisement
2.
INSTALLATION
2.1.
REAR PANEL
The following sections describe the purpose of the rear panel connectors of the 8010TM. Sections
2.1.1 to 2.1.8 describe the specific signals that should be connected to the 8010TM.
2.1.1. Digital Video Connections
SDI IN:
A BNC connector for input of 10 bit serial digital video signals compatible with the
SMPTE 259M standard.
SDI BYPASS: A BNC connector for output of 10 bit serial digital video signals compatible with the
SMPTE 259M standard. This output will normally be the video input with VITC and
characters inserted onto it. When the optional SDI bypass relay is activated (on power
failure or from the front panel) the SDI BYPASS output will be a direct relay connection
to the SDI IN.
SDI OUT:
A BNC connector for output of 10 bit serial digital video signals compatible with the
SMPTE 259M standard. This output will normally be the video input with VITC and
characters inserted onto it. When the optional SDI bypass relay is activated (on power
failure or from the front panel) the SDI OUT output will not have any video signal on it.
2.1.2. Analog Monitor Video Connections
The analog composite monitor output is optional and may not be fitted on your unit.
MONITOR OUT:
This output will normally be an analog video copy of the video on the SDI OUT
connector. When the optional SDI bypass relay is activated (on power failure or from the
front panel) the MONITOR OUT outputs will not have any video signal on them.
2.1.3. Linear Time Code Connections
LTC OUT:
A male XLR connector for output of SMPTE/ EBU linear time code from the generator.
(Balanced)
LTC IN:
A female XLR connector for input of SMPTE/ EBU linear time code for the reader.
(Balanced)
INSTALLATION
Figure 2-1: 8010TM Rear Panel
Two BNC connectors for output of the optional composite analog encoder.
Revision 1.5.1
Model 8010TM SDI Time Code Master Manual
Page 2-1
Advertisement
Table of Contents
