Selecting The Film Type - evertz 4025TR Instruction Manual

!
OPERATION
operating from the KeyLog TRACKER™ software, the Ink number register
can also be inserted into the VITC.
Press the INK key to access the Ink number generator. Enter the footage
and frames part of the number follow the procedure outlined in the manual
section 3.10.2.
Press the INK key and then the TIME/UB key to display the Ink number
prefix on the front panel.
conjunction with the arrow and numeric keys to set the Ink number prefix.
Entering prefixes is a two step process.
Press the ENTER key to proceed to the numeric prefix entry. The leftmost
digits of the display will indicate INK PREFIX and the dual functioned keys
assume their numeric values. Pressing any numeric key will place the new
value into the display, starting at the right.
assumed to be zero.
clearing of the display. Re-enter the correct value.
When the required number of digits of prefix are entered, press the ENTER
key to proceed to prefix letter selection. The leftmost digits of the display
will indicate INK PREFIX. The previously entered numbers will be shown
with a letter or space to the extreme right of the display. Press the vertical
arrow keys ($, %) to select the correct prefix letter. Select the space
character if you do not want a letter encoded. (See the ACMADE Letter
code table in Figure 3-12 for a list of the letter suffixes currently supported).
When the desired letter is selected press ENTER to complete the Ink prefix
entry. Pressing the CLR key will cancel the prefix entry mode without
changing any data.
The numeric keys return to their normal functions, and the prefix message
stops blinking when the data entry has been completed by pressing the
ENTER key or cancelled by pressing the CLR key.
Prefix entry mode must be terminated (the prefix message will stop blinking)
before any of the front panel keys will resume their normal operation.

3.10.6 Selecting the Film Type

Use the Film tab of the Configuration screen to select the film type.
Selection of the Film Gauge is performed using the setup menu displayed
on the character generator. Press the SETUP key to access the setup
menu. Using the " & # keys drop down the FILM menu. Use the $ & %
Model 4025TR Film Footage Encoder Manual
The ENTER and CLR keys are used in
Attempts to enter too many digits will result in
Leading blank digits are
Page 3-50