Table of Contents
Advertisement
INSTALLATION
Figure 2-11: Philips FRID Pulse Specification
2.12.3 FDL-60
The documentation for the FDL-60 shows that the FRID pulse can be found
as follows:
1.
FDL 60 A11/A13/C11/C13:
FD 353 Intermediate board/EXT 2/B25/pin 17, GND pin 18
2.
FDL 60 B1/B3/C1/C3:
FD AP DF 632-002, -003/EXT 2/B25 J34/pin 17, GND pin 18
3.
FDL 60 B2/B4 up to Serial No. 340:
FD AP DF 632-001/FRAME ID OUT/J31/BNC with interface:
FD AP DF 632-001/EXT PAN CONTROL/B15 J35/pin 13,
GND pin 14
4.
FDL 60 B2/B4 starting with Serial. No. 341 and C2/C4:
FD AP DF 632-002, -003/EXT 2/B25 J34/pin 17, GND pin 18
TTL - output, max. current: 40 mA
Since there are a number of similar signals, we recommend that you check
out the signal with an oscilloscope while the telecine is in play.
The telecine type item on the Engineering Toolbox Hardware Menu must
be set to QUADRA/FDL. (See section 3.6.4)
2.12.4 Philips FDL-90
The biphase tach pulse is available on the 9 pin D Sepmag connector on
the telecine. Connect pins 1 and 5 from this connector to pins 3 and 7 of
the 9 pin parallel I/O connector of the 4025TR respectively.
ground (pin 7 on the telecine connector to pin 6 on the 4025TR connector.
Note that the pulse output should be set to 10 pulses per film frame by
Model 4025TR Film Footage Encoder Manual
Connect
Page 2-25
Advertisement
Table of Contents
