evertz 4025TR Instruction Manual page 82

!
OPERATION
Note: * RDR 1 is the reader mapped to the Video generator, RDR 2 is the
reader mapped to the Audio generator. The RDR MAPPING Menu item is
used to map the LTC or VITC readers
See sections 3.3.2, 3.9.7 and 3.9.8 for a complete discussion on the use of
multiple VITC lines in the 4025TR.
When the normal modes of the GEN ASSIGN menu are
selected, the LTC generator contains the same information as
the VITC1 lines. The K
ability to configure the 4025TR hardware in many combinations
not possible with the setup menu. In the extended modes, the
LTC generator and VITC generator operate independently.
When the 4025TR is in one of these 'extended Tracker' modes,
the GEN ASSIGN menu item will show EXTENDED MODE. If
this mode is highlighted you can select one of the normal
modes, but you will not be able to return to the extended mode
from the menu system.
K
EY
When EDGE data is placed in the user bits, it may consist of a
variable length footage and frame number plus a numeric prefix.
See the FILM drop down menu items (See section 3.10 for a
complete definition of the edge number modes.)
There are four one-line modes available. In these modes there is only one
set of VITC lines generated (called VITC1). The LTC generator contains
the same information as the VITC generator.
Select RUN EDGE to free run the Video time numbers. The
Video time is put into the LTC and VITC 1 generator time and
the film edge numbers are put into the user bits. You will be
able to start and stop the Video time using the HOLD key.
Select CINE NUM to slave the Video time to the telecine's
biphase.
generator time and non-incrementing numeric (hexadecimal)
user bits to be entered from the front panel. In this mode, user
bits may be used for scene and take numbers, or roll numbers,
etc.
Select CINE EDGE to slave the video time to the telecine's
biphase.
generator time and the film edge numbers are put into the user
bits.
Select LRDR EDGE to slave the video time to the LTC reader.
Select VRDR EDGE to slave the video time to the VITC
reader.
Model 4025TR Film Footage Encoder Manual
EY
L TRACKER™ software.
OG
The Video time is put into the LTC and VITC 1
The Video time is put into the LTC and VITC 1
The Video time is put into the LTC and VITC 1
L TRACKER™ software has the
OG
You will have to do this from the
Page 3-14