Table of Contents
Advertisement
TECHNICAL DESCRIPTION
This will run the Flash loader program in its default configuration:
COM1, 38400 baud, and software flow control. If you connected the
computer using COM2 you will need to use additional command line
parameter to specify the COM port as follows:
FL DC32A1.HEX /p2
If you set up the 4025TR for programming at 9600 baud you will need
to use additional command line parameter to specify the baud rate as
follows:
FL DC32A1.HEX /b9600
Entering the FL with no file name will generate a usage message to
show you all the available options for the Flash Loader program.
5.
The Flash Loader will announce that it is erasing the FLASH PROM.
The 4025TR front panel and VCG will show FLASH ERASING....
This message may only be visible 1 or 2 seconds.
6.
When the Flash PROM is erased, the Flash loader will start to send
the new firmware to the 4025TR. The Flash loader will give a status
report as it sends each line of the HEX file to the 4025TR.
programming the 4025TR front panel and VCG will show LOADING -
XXXXX. The XXXXX will be the actual PROM address currently being
programmed.
7.
If there are programming errors an appropriate message will be
shown on the 4025TR front panel and VCG. You will need to abort
the Flash loader program by pressing the ALT+x keys on your
computer keyboard. (Hold the ALT key down while pressing the x
key.) Repeat steps 3 to 6 to try to correct the problem. If you still
have trouble, try programming at 9600 baud.
8.
The reprogramming will be complete when the Flash Loader
announces "Hex file transmitted successfully" and returns you to the
DOS prompt.
program memory if programming is successful. As a part of the
4025TR boot-up cycle it will say SWITCH TO FLASH to indicate that
it is running on the FLASH EPROM now.
Model 4025TR Film Footage Encoder Manual
The 4025TR will automatically switch to its FLASH
During
Page 6-27
Advertisement
Table of Contents
