Table of Contents
Advertisement
SYSTEM DIAGNOSTICS
NOVRAM RETRY COUNT EXCEEDED
VCG OVERRUN
INVALID MICROPROCESSOR
5.2.2
KeyKode Related Messages
KK JAM: FEET DIFFERS
KK JAM: FRAMES DIFFERS
KK JAM: KEY INFO DIFFERS
KK JAM: PREFIX DIFFERS
KEYKODE OFF
KEYKODE MISSING
KEYKODE INVALID
5.2.3
KeyKode Head Offset Learning Related Messages
NO LRN: CINE NOT LOCKED
NO LRN: NOT IN EDGE UB MODE
NO LRN: KK JAM NOT OFF
NO LRN: DON'T USE 7 DIGITS
NO LRN: ERROR > +99 FRAMES
NO LRN: ERROR > +99 FRAMES
NO LRN: KEYKODE MISSING
NO LRN: KEYKODE INVALID
NO LRN: ENGINEERING MODE OFF
HEAD OFFSET LIMIT EXCEEDED
HEAD OFFSET ADJUSTED UP
HEAD OFFSET ADJUSTED DOWN
HEAD OFFSET OK
Model 4025TR Film Footage Encoder Manual
The nonvolatile memory was unable to be
programmed
Indicates a timing overrun related to the
character inserter. It is normal for this message
to occur after accessing the menu system.
The microprocessor is invalid for the firmware
version.
The character generator has updated to the new
edge number.
Indicates KK JAM = OFF has been selected.
Biphase is indicating that the telecine is in motion
but no KeyKode is being received.
An illegal or invalid KeyKode combination has
been selected.
Reasons for head offset learning failure
An incorrect reference frame number was
entered during the learn procedure
Biphase is indicating that the telecine is in motion
but no KeyKode is being received.
An illegal or invalid KeyKode combination has
been selected.
Turn on the Engineering mode DIP switch to
perform head offset learning
An attempt to learn a head offset beyond the
maximum has been attempted.
The head offset value has been adjusted up or
down.
The head offset has not been adjusted because
it is already the correct number.
Page 5-6
Advertisement
Table of Contents
