Table of Contents
Advertisement
INSTALLATION
TRACKER™ logs the timecodes, KeyKode, ink code and pulldown
relationship of the film transfer during the transfer.
It is recommended that the computer interface be connected first, and that
you install the K
way you will be able to use the power of the computer to help you configure
the 4025TR correctly.
When K
L
TRACKER™ is in control of the 4025TR, all settings that are
EY
OG
configured with the SETUP menus will be overwritten. It is recommended
that you always use K
In order to connect your 4025TR to your computer, you will have to make a
cable as shown below. Use this cable to connect the computer's COM port
to the Serial I/O connector on the rear of the 4025TR.
4025TR End
9 pin D Male Pin
TxD
RxD
Sig Gnd
Frame Gnd Shield ----drain-----
Figure 2-9: Cable to Connect 4025TR to PC Communications Port
2.10.2 Installing K
Insert the first KeyLog TRACKER™ CD-ROM into the PC's CD-ROM drive
and click on the Start button and then click Settings. Click on the Control
Panel,
then
installation program will guide you through the installation procedure.
Once the installation is complete, click on the Start button and then click
Programs. Select the "Evertz Products" program group and click on the
KeyLog TRACKER™ icon.
You are presented with the K
"Login" dialog box. Enter "user" as a user name, leave the password area
blank and click the "OK" button.
Model 4025TR Film Footage Encoder Manual
L
TRACKER™ software on your computer. In that
EY
OG
L
TRACKER™ to configure the hardware.
EY
OG
Belden9501 Pin
5
8
6
----drain-----
L
TRACKER™
EY
OG
ADD/Remove
Programs.
L
EY
OG
Computer End
9 pin D Female
2
RxD
3
TxD
5
Sig Gnd
7
RTS
8
CTS
4
DTR
1
DCD
6
DSR
9
RI
Shield Frame Gnd
The
K
L
EY
OG
TRACKER™ Splash screen and the
TRACKER™
Page 2-14
Advertisement
Table of Contents
