Selecting How The Keykode Prefix Is Displayed In The Vcg - evertz 4025TR Instruction Manual

!
!
KEYINFO
INFO OFF
INFO ON
INFO CHECK
OPERATION
barcode numbers is detected.
information on how to set the error window.) This is necessary
to track the discontinuous edge numbers that would be
encountered when searching select take rolls in shuttle. This
value shows the amount of error in film frames that the 4025TR
will allow, (in shuttle modes), between the biphase-based
numbers and the barcode numbers. When this window value is
exceeded, the barcode numbers will approximately update the
biphase-based numbers. The biphase-based numbers will be
exactly updated the next time the telecine achieves locked play
speed. The default value for the window is 30 frames.
JAM ALWAYS is the preferred mode for most circumstances where KeyKode
is being used.
In JAM ALWAYS mode, if you shuttle across a splice to a marked frame there
maybe a small discrepancy between picture & numbers. To eliminate this,
put the telecine in PLAY for a few seconds.
3.4.2

Selecting how the KeyKode Prefix is Displayed in the VCG

KEYINFO Is used to select the way in which the KeyKode numbers will be
displayed in the character inserter.
Select INFO OFF when using non-KeyKoded stock and you
wish to blank the prefix part of the KeyKode display.
character generator will show only the footage and frames.
Select INFO ON to display the entire KeyKode number.
INFO CHECK is always enabled in the KeyLog TRACKER™ software. The
Dropout delay item of the Configuration screen Film tab sets how much film
must pass before the indicator becomes active
When using an external barcode reader it is important to know if
the edge numbers being displayed in the 4025TR are being
updated from the barcodes, or only from the telecine biphase.
With INFO CHECK the 4025TR will change the font of the Key
info part of the film edge number window when 4025TR detects
that the barcode information is missing, and the edge numbers
are being updated only by the telecine biphase. In the Tiny
character size, the Key Info part of the edge number will be
shown in inverse video.
Model 4025TR Film Footage Encoder Manual
(See section 3.7.2 for
Page 3-20
The