Selecting When The Barcode Numbers Update The Edge Number Information - evertz 4025TR Instruction Manual

OPERATION
before the 4025TR will use the KeyKode information it receives.
4025TR maintains separate head offset values for 16 mm and 35 mm film
types for each transfer speed. Once calibrated, the 4025TR automatically
uses the correct head offset value for your configuration. The head offset
calibration is normally only required during installation. A summary of the
Head offsets is available using the KK HEAD OFFSET item in the CONFIG
drop down menu of the setup menu.
description of the head offset learning process).
We highly recommend that you perform the head offset learning from the
Telecine Setup screen of the KeyLog TRACKER™ software. The resulting
head offsets will then be stored in the Telecine setups in the computer, and
will be sent to the 4025TR hardware each time a configuration set is applied.
3.11.1 Selecting When the Barcode Numbers Update the Edge
number Information
Use the KeyKode pulldown on the Codes tab of the Configuration screen to
select how the Barcode numbers will update the biphase based edge
numbers.
Selection of the way in which data received from the KeyKode reader will
affect the logical KeyKode generator is performed using the setup menu
displayed on the character generator. When KK JAM is set to ONCE,
PLAY, or ALWAYS, the KeyKode numbers are read by the bar code reader
and inserted into the logical KeyKode generator with the appropriate offset
compensation. When the KK JAM is set to NEVER, the logical KeyKode
generator updates only from the biphase of the telecine.
Press the SETUP key to access the setup menu. Using the " & # keys
drop down the FILM menu. Use the $ & % keys to highlight the KK JAM
menu item and press the SELECT key to show the KK JAM sub menu.
The currently programmed KeyKode jam mode is shown in reverse video.
Press the $ & % keys one or more times to select the desired KeyKode
jam mode. Press the SETUP or CLR keys to exit the setup menu, or press
the SELECT key to return to the FILM drop down menu.
The 4025TR permits three different methods of updating the biphase based
numbers with the barcode data. The KKODE LED on the front panel,
shows each time a valid Barcode number is read.
Select NEVER to disable automatic data updates from the KeyKode
reader. The 4025TR will use the biphase exclusively to update the edge
numbers. The front panel KKODE entry mode may be used to manually
enter edge numbers from non-KeyKoded stock. This may also be helpful
Model 4025TR Film Footage Encoder Manual
(See section 2.13.3 for a full
The
Page 3-56