Table of Contents
Advertisement
#
8.6 INSTALLING THE RESEARCH IN MOTION KEYKODE READER ON YOUR TELECINE
KEYKODE READER INSTALLATION
ensure that shielded cable is used, and that the shield is connected
through.
8.5.4 Setting the Correct Operating Modes
Consult the Cinema Products operating manual section 2.1 and 2.2 for
information on determining the operating mode of the CP reader.
necessary, remove the top cover from the unit and select KeyKode Direct
mode.
The Cinema Products unit must be set to KEYKODE DIRECT mode for proper
operation with the 4025TR.
Connecting the biphase input of the Cinema Products unit is not required
when operating in KeyKode direct mode. Setting the mechanical offset
switches in the Cinema Products units is only required if biphase
connections are hooked up.
A toggle switch on the front panel enables and disables the beep which
indicates when a barcode has been successfully read. Enabling the beep
is helpful when checking out the installation, but may be annoying during
normal day to day operation.
Consult the Cinema Products manual for information about the use of other
toggle switches on the unit.
8.6.1
Mounting the Reader Head
Follow the directions received with the Research in Motion DigiSync unit.
The reader head and mounting bracket are separate and will have to be
assembled before mounting on the telecine. The installation instructions
are contained on pages separate from the manual.
8.6.2
Connecting the Reader Head to the DigiSync Console
Refer to section 3 of the DigiSync manual for information on connecting the
reader head to the DigiSync console. The cable supplied with the DigiSync
is 12 feet long. If you wish to mount the console more than 12 feet from
the telecine, required, this cable may be extended to a maximum length of
100 feet. When extending the cable, care should be taken to ensure that
shielded cable is used, and that the shield is connected through.
Model 4025TR Film Footage Encoder Manual
If
Page 8-9
Advertisement
Table of Contents
