Selecting The Reading Mode Of The Ltc/Vitc Reader; Programming The Film Transfer Modes - The Film Menu; Selecting When The Film Edge Numbers Are Updated From The Keykode Reader - evertz 4025TR Instruction Manual

RDR MAPPING
VIDEO AUDIO
LTC VITC
VITC LTC

3.4 PROGRAMMING THE FILM TRANSFER MODES - THE FILM MENU

KK JAM
NEVER
ONCE
PLAY
ALWAYS
OPERATION
3.3.5

Selecting the Reading Mode of the LTC/VITC Reader

The LTC and VITC readers may be assigned to bring data to either the
Video timecode or Audio timecode generators. The VRDR and LRDR 1
CODE IN LED's on the front panel will be on when the respective readers
are receiving valid timecode. LRDR 2 is not used at this time, but the
display will show the data from LRDR 1.
The reader mapping will be shown on the GEN ASSIGN menu. (See
section 3.3.1) The operation of the readers when there is no incoming
code is controlled by the NO CODE JAM setting in the Toolbox menu.
(See section 3.7.7)
RDR MAPPING
readers to the Video and Audio timecode.
Select LTC VITC to assign the LTC reader to the Video
timecode and the VITC reader to the Audio timecode.
Select VITC LTC to assign the VITC reader to the Video
timecode and the LTC reader to the Audio timecode.
Use the Codes and Film Tabs of the Configuration screen to configure the
items on the Film menu.
3.4.1 Selecting when the Film Edge numbers are updated from the
KeyKode reader
KK JAM Is used to select the way in which data received from an
external KeyKode reader will affect the information in the
KeyKode register.
encoded into the time code outputs if the Generator Assignment
is set to any mode except CINE NUM. When KK JAM is set to
ONCE, PLAY, or ALWAYS, the KeyKode numbers are read by
the bar code reader and inserted with the appropriate offset
compensation.
displayed in the character generator or placed into the VITC2 or
3-line VITC. A truncated film barcode number may be placed in
the user bits of the timecode output in one of the EDGE modes.
(See section 3.10.1 for a discussion of how the film edge
numbers are encoded into the user bits.)
Model 4025TR Film Footage Encoder Manual
Is used to assign the LTC and VITC timecode
The KeyKode register information is
The complete KeyKode number may be
Page 3-18