Setting The Correct Digisync Operating Modes - evertz 4025TR Instruction Manual

#
#
#
KEYKODE READER INSTALLATION

8.3.2 Setting the Correct DigiSync Operating Modes

Consult the DigiSync operating manual section 4.4 for a full description of
DigiSync operating modes that are relevant to its use with the 4025TR.
Several Function key sequences are available on the DigiSync to provide
the user with the ability to control various features of the DigiSync. Each
sequence consists of pressing the [FUNCTION SET] key followed by a
numbered key ([1] through [9])
[FUNCTION SET 1] [1] allows the user to change between the Upper and
Lower sensors on the dual sensor Evertz 35 mm head. The
Lower sensor is located closest to the mounting bracket and is
normally used when reading KeyKode. The Upper sensor is
located farthest away from the mounting bracket, and is used for
reading KeyKode on film that was rewound before it was loaded
into the camera.
[FUNCTION SET 1] [4] enables and disables the "serial broadcast mode".
For use with the 4025TR, the DigiSync serial broadcast mode must be
enabled.
[FUNCTION SET 1] [9] displays the version number of the current
firmware inside the DigiSync unit. At the time of this writing,
DigiSync version 4.0.03E is the recommended version for use
with the 4025TR. Although versions 3.1 and 4.0 have been
tested for compatibility with the 4025TR, we recommend that
you update to the current version. Contact the Evertz Factory
for information on updating the DigiSync software version.
[FUNCTION SET 2] [5] sets the desired serial communications protocol to
either WELCH ALLYN or WELCH ALLYN modified.
[ENTER] to show the protocol which is selected.
For use with the 4025TR, the DigiSync serial protocol must be set to
WELCH ALLYN.
After resetting to factory defaults, check the settings to make sure they are
configured properly.
Once one of the above functions is selected, the [+] and [-] keys are used
to change the current settings. Press [ENTER | =] or [C/CE] to exit the
function select mode of the DigiSync.
Model 4025TR Film Footage Encoder Manual
Press
Page 8-7