Table of Contents
Advertisement
!
OPERATION
character generator. The INK key is used to display the Ink number on the
front panel.
3.10.1 Configuring the Film Edge Number Operating Modes
Selection of the desired mode of operation for the generator is performed
using the setup menu displayed on the character generator. Press the
SETUP key to access the setup menu. Using the " & # keys drop down
the TIMECODE menu. Use the $ & % keys to highlight the GEN ASSIGN
menu item and press the SELECT key to show the generator operational
modes sub menu. Figure 3-10 summarizes how the KeyKode numbers are
encoded in the various modes.
assignment mode is shown in reverse video. Press the $ & % keys one or
more times to select the desired mode of operation.
•
To put edge numbers in the user bits of the LTC and primary
VITC generators, select one of the EDGE modes.
•
To put the full KeyKode into the secondary VITC generator
select one of the + KEYKODE modes.
•
To put the full KeyKode and film format into the second line of
the 3-line VITC generator select on of the +3 LINE modes.
Press the SETUP or CLR keys to exit the setup menu, or press the
SELECT key to return to the TIMECODE drop down menu. (See section
3.9.2 for more information about the various time code modes)
3.10.2 How to Set the KeyKode Numbers - Manual Entry
The 4025TR is fitted with an interface for connection to an external
KeyKode reader. These readers automatically read the film edge codes
from KeyKoded stock and the 4025TR automatically updates the logical
Keykode generator.
operation with KeyKode. When the Keykode information is not readable, or
in other cases where you need to manually enter a KeyKode number follow
this procedure.
Use the Set Codes window to manually enter Keykode numbers.
Note that if the KK JAM mode of the 4025TR is set to ONCE, PLAY, or
ALWAYS, the next valid data from the KeyKode reader will overwrite the data
that was manually entered from the front panel. Use the KK JAM OFF mode
to prevent this from happening.
Model 4025TR Film Footage Encoder Manual
The currently programmed generator
See section 3.11 for further information about
Page 3-45
Advertisement
Table of Contents
