Table of Contents
Advertisement
INSTALLATION
The following simple procedure will help you establish that the 4025TR is
properly installed, and that it is configured correctly for your application.
1.
Make note of the key number on a piece of reference film. This
number is usually the Key number of the frame where a
reference KeyKode dot is located (i.e. on the whole foot mark).
Mark this reference frame with a punch or grease pencil.
2. Place this film on the telecine, with the reference frame in the
gate.
3. a) If you are using the 4025TR in Local mode, use the Setup
menu to set the 4025TR to the following settings:
•
GEN MODE to CINE EDGE (See section 3.3.1)
•
VID DROP FRAME to NON DROP FRAME (See section
3.3.3)
•
KK JAM to NEVER (See section 3.4.1)
•
FILM TYPE to Match the film stock you have placed on
the telecine (See section 3.4.3)
•
FILM RATE to match your telecine transfer rate. If you
are working in NTSC do the accuracy test for 24 FPS
first, as this is the most critical setup. (See section 3.4.4)
•
VIDEO DELAY to match the path delay (in video fields)
between the telecine output and the 4025TR input.
•
PRESTORE DELAY to zero.
b) Turn on the 4025TR's character windows for Generator time
and Edge code (KeyKode) as described in section 3.12.1
c) Enter the key number of the reference frame into the
KKODE register as described in section 3.10.2
d) Set the time of the Video timecode generator to 01:00:00:00
as described in section 3.9.3.
4. a) If you are using the KeyLog TRACKER™ software to control
the 4025TR in Remote mode, open the System Default
telecine setup and set the Video Delay parameter to match
the path delay (in video fields) between the telecine output
and the 4025TR input.
Configuration called Biphase Accuracy test. Make sure that
the telecine tab parameters match those of the System
Default Telecine setup.
4025TR. It will place the hardware in the correct mode to
perform the following test. See the section titled "First Time
Setup" in the KeyLog TRACKER™ manual for detailed
information.
b) Use the Set Codes window of the KeyLog TRACKER™
software to enter the key number of the reference frame into
the KeyKode register, and set the Video time code to
01:00:00:00
Model 4025TR Film Footage Encoder Manual
Apply the configuration to the
Open the system default
Page 2-21
Advertisement
Table of Contents
