How To Set The Video Generator User Bits - evertz 4025TR Instruction Manual

!
OPERATION
required number of digits are entered, then press the ENTER key to
complete the data entry into the generator time.
Attempts to enter too many digits, or make illegal entries, i.e. 65 minutes,
will result in the display returning to the last valid time entry made.
Re-enter the correct value and press the ENTER key. Pressing the CLR
key will cancel the data entry mode without changing any data.
The numeric keys return to their normal display functions when the data
entry has been completed by pressing ENTER or cancelled by pressing the
CLR key. The display prompt will return to its steady on state when data
entry mode has been completed.
Numeric entry mode must be terminated (the display prompt will be on
steady) before any of the front panel keys will resume normal operation.
In the RUN EDGE mode, press GEN RUN / HOLD to start or stop the
Video generator clock. In the CINE modes, the Video generator will start
and stop with the telecine biphase.

3.9.4 How to Set the Video Generator User Bits

When entering user bits data make sure that the GEN ASSIGN menu is set
to CINE NUM mode. If it is in one of the EDGE OR RDR modes, use the
setup menu as described in section 3.3.1 to select the NUM user bit mode.
Press the VID TC key to display the Video logical generator. Press the
TIME / UB key to display the Video generator user bits if they are not
already displayed. The colons of the display are blanked when user bits
are displayed. The ENTER and CLR keys are used in conjunction with the
numeric keys to set the generator user bits.
Press the ENTER key to recall the last User Bits that you entered into the
generator. The display prompt at the left of the display will blink while data
entry mode is active, and the dual functioned keys are now changed to
their numeric values. If you want to re-enter these User Bits press the
ENTER key to complete the data entry into the generator.
Pressing any numeric key will clear the previous value and place the new
value into the numeric display, starting at the right. Pressing the SHIFT
key and the numeric keys 0 to 5 will enter the corresponding hexadecimal
values A to F.
required number of digits are entered, press the ENTER key to complete
the data entry into the generator User Bits.
Attempts to enter too many digits will result in the display being blanked.
Re-enter the correct value and press the ENTER key. Pressing the CLR
key will cancel the data entry mode without changing any data.
Model 4025TR Film Footage Encoder Manual
Unentered digits are assumed to be zero. When the
Page 3-39