Engineering Tool Box Menu - evertz 4025TR Instruction Manual

GEN ASSIGN
RUN EDGE
CINE NUM
CINE EDGE
LRDR EDGE
CINE VRDR+KEYKODE
LRDR VRDR+KEYKODE
CINE VRDR 3 LINE
LRDR VRDR 3 LINE
EXTENDED MODE
OPERATION
To enter the setup menus, press the SETUP key. The character generator
will show the last drop down menu that was used with the currently
selected item highlighted. The two horizontal arrow keys (", #) allow you
to move horizontally to another drop down menu. Using these two keys
you can quickly scan the entire menu system for the item you wish to
change.
The two vertical arrow keys ($, %) allow you to move vertically within the
drop down menus. When you have selected the desired menu item, press
the SELECT key to reveal the sub menu choices for that item. Use the two
vertical arrow keys ($, %) to move vertically within the sub menu. When
you have selected the desired sub menu choice press the SELECT key to
save your choice and you will return to the drop down menu.
When you have made all the desired changes, press the SETUP or CLR
keys to return to the normal display mode.
Each of the menu items is described in the following sections, with an
explanation of what each choice does. Section 3.3 describes the items on
the TIMECODE drop down menu. Section 3.4 describes the items on the
FILM drop down menu. Section 3.5 describes the items on the CONFIG
drop down menu.
To aid in finding the descriptions of the various menu items in the following
sections, the drop down menu items and its sub menu items are shown in
the margin of the manual, next to the description as shown.
3.2.1

Engineering Tool Box Menu

The Toolbox menu allows the advanced user to change various internal
parameters of the 4025TR, or to invoke several advanced diagnostic
modes. Only advanced users should use this menu, as improper use can
overwrite Telecine type, biphase rate and other user setups.
The Engineering Toolbox should only be used to configure the 4025TR for
Local mode operation.
configured using the K
into Remote mode, the K
re-apply the configuration, so that the computer and hardware are using the
same configuration settings.
The 4025TR Toolbox menu system consists of three drop down menus.
The titles of each of the drop down menus are shown on the top line of the
character display.
reveals a sub-menu showing the choices for that item. Figure 3-9 is an
overview of the Toolbox menu and shows all the menu choices and where
you will find the menu items. Note that some menu choices will be hidden
depending on the programmed mode of operation.
Model 4025TR Film Footage Encoder Manual
Under normal operation the 4025TR will be
L TRACKER™ software. When the 4025TR is put
EY OG
L TRACKER™ software will prompt the user to
EY OG
Selecting an item on one of the drop down menus
Page 3-9