Checking And Adding Conditioner Roll Timing Gearbox Lubricant - MacDon R113 Unloading And Assembly Instructions

7.4 Checking and Adding Conditioner Roll Timing Gearbox
Lubricant
The conditioner roll timing gearbox is located inside the drive compartment at the right side of the
mower conditioner.
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and
remove the key from the ignition before leaving the operator's seat for any reason.
IMPORTANT:
Check the conditioner roll timing gearbox lubricant level when the lubricant is warm. If the lubricant is cold, idle the
machine for approximately 10 minutes prior to checking.
1. Lower mower conditioner to the ground, and adjust header angle with center-link so that cutterbar is level. Turn
engine off, and remove key.
2. Open a cutterbar door. With a spirit (bubble) level, check that cutterbar is level in fore-aft direction. Adjust
header angle as required.
3. Open the right driveshield. For instructions refer to
4. Clean around lubricant sight glass (A) and breather
plug (B) on inboard side of the conditioner roll
timing gearbox.
5. Ensure that the lubricant level is at the top of the
sight glass. If necessary, add lubricant through plug (B).
Refer to the inside back cover of this manual for
lubricant information.
6. Replace plug (B) and tighten.
7. Close right driveshield. For instructions refer to
Closing Driveshields, page
214075
PERFORMING PREDELIVERY CHECKS
9.1 Opening Driveshields, page
9.2
85.
Figure 7.9: Roll Timing Gearbox
55
83.
Revision A