Modes; Drive Modes - YASKAWA G7 Series Technical Manual

Run Indicator
The status of the "RUN" indicator is shown in Table 3.5 when the Drive is in either the "LOCAL" or "REMOTE" mode.
Indicator Status
Blinking
Off
Stop Indicator
The status of the "STOP" indicator is shown in Table 3.6 when the Drive is in either the "LOCAL" or "REMOTE" mode.
Indicator Status
On
Blinking
Off

Modes

This section describes the Drive's modes and switching between modes.

Drive Modes

The Drive's user parameters and monitoring functions are organized in groups called modes that make it easier to
read and set user parameters.The Drive is equipped with 5 modes.
The 5 modes and their primary functions are shown.
Mode
Drive mode
Quick programming mode
Advanced programming mode
Verify mode
Autotuning mode*
* Always perform autotuning with the motor before operating using vector control. Autotuning mode will not be displayed during operation or when an
error has occurred. The default setting of the Drive is for open-loop vector control 1 (A1-02 = 2).
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 3.5 RUN Indicator
On
Table 3.6 STOP Indicator
Drive is decelerating to a stop or stopped.
Drive is in a run condition but the frequency reference is less than the
minimum output frequency E1-09, or the Drive is running in "REMOTE" mode and the
"STOP" key on has been pressed.
Drive is running.
Table 3.7 Modes
The Drive can be run in this mode.
Use this mode when monitoring values such as frequency references or output cur-
rent, displaying fault information, or displaying the fault history.
Use this mode to reference and set the minimum user parameters to operate the
Drive (e.g., the operating environment of the Drive and Digital Operator).
Use this mode to reference and set all user parameters.
Use this mode to read/set user parameters that have been changed from their fac-
tory-set values.
Use this mode when running a motor with unknown motor parameters in the vector
control mode. The motor parameters are calculated and set automatically.
This mode can also be used to measure only the motor line-to-line resistance.
Condition
Drive is running.
Drive is decelerating to a stop.
Drive is stopped.
Condition
Primary function(s)
Drive Mode Indicators
5
3-