YASKAWA G7 Series Technical Manual page 362

Storing Drive Set Values in the Digital Operator (READ)
To store Drive set values in the Digital Operator, make the settings using the following method.
Step
Digital Operator Display
No.
1
2
3
4
5
6
INV→OP READING
7
READ COMPLETE
8
An error may occur while saving to memory. If an error is displayed, press any key to cancel the error display
and return to the o3-01 display.
-144
6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Table 6.1 READ Function Procedure
-ADV-
** Main Menu **
Press the Menu Key, and select advanced programming mode.
Programming
-ADV-
Initialization
Press the DATA/ENTER Key, and select the parameter monitor display.
A1 - 00=1
Select Language
-ADV-
Display o3-01 (Copy Function Selection) using the Increment Key and Decrement
COPY Function
Key.
o3 - 01=0
Copy Funtion Sel
-ADV-
Copy Funtion Sel
Press the DATA/ENTER Key, and select the parameter setting display.
o3-01= 0
*0*
COPY SELECT
-ADV-
Copy Funtion Sel
Change the set value to 1 using the Increment Key.
o3-01= 1
*0*
-ADV-
READ
Set the changed data using the DATA/ENTER Key. The READ function will start.
-ADV-
READ
If the READ function ends normally, End is displayed on the Digital Operator.
-ADV-
Copy Funtion Sel
The display returns to o3-01 when a key is pressed.
o3 - 01=0
*0*
COPY SELECT
Explanation