Table of Contents
Advertisement
Copying Parameters
The Digital Operator can perform the following three functions using the built-in EEPROM (non-volatile
memory).
Store Drive parameter set values in the Digital Operator (READ)
•
Write parameter set values stored in the Digital Operator to the Drive (COPY)
•
Compare parameter set values stored in the Digital Operator with Drive parameters (VERIFY)
•
Related Parameters
Name
Parameter
Number
Display
Copy Function
This parameter controls the
Selection
copying of parameters to and
from the Digital Operator.
0: COPY SELECT (no function)
1: INV --> OP READ - All
2: OP --> INV WRITE - All
o3-01
3: OP<-->INV VERIFY -
Copy Function
Sel
Note: When using the copy
Copy Allowed
Enables and disables the Digital
Selection
Operator copy functions.
o3-02
0: Disabled - No Digital Operator
Read Allowable
1: Enabled - Copying allowed.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Setting
Description
Range
parameters are copied from the
Drive to the Digital Operator.
parameters are copied from the
Digital Operator to the Drive.
0 to 3
Parameter settings in the Drive
are compared to those in the
Digital Operator.
function, the Drive model
number (o2-04), software
number (U1-14), and control
method (A1-02) must match or
an error will occur.
0 to 1
copy functions are allowed.
Digital Operator Functions
Control Methods
Change
Open
Factory
V/f
during
Loop
Setting
V/f
with
Operation
Vector
PG
0
No
A
A
0
No
A
A
Open
Flux
Loop
Vector
Vector
1
2
A
A
A
A
A
A
143
6-
Advertisement
Table of Contents
Troubleshooting
