YASKAWA G7 Series Technical Manual page 320

PID Control Methods
There are four PID control methods. Select the method by setting parameter b5-01.
Set Value
1
2
3
4
PID Input Methods
Enable PID control using parameter b5-01, and set the PID target value and PID feedback value.
PID Target Value Input Methods
Select the PID control target value input method according to the setting in b1-01 (Reference Selection).
Normally, the frequency reference selected in b1-01 is the PID target value, but you can also set the PID target
value as shown in the following table.
PID Target Input Method
Multi-Function Analog Ter-
minal A2 Input
MODBUS register 0006H
Pulse train input
PID Feedback Input Methods
Select one of the following PID control feedback input methods.
Input Method
Multi-function analog input
Pulse train input
INFO
-102
6
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
PID output becomes the Drive output frequency, and D control is used in the difference between PID tar-
get value and feedback value.
PID output becomes the Drive output frequency, and D control is used in the PID feedback value.
PID output is added as compensation value of the Drive output frequency, and D control is used in the
difference between PID target value and feedback value.
PID output is added as compensation value of the Drive output frequency, and D control is used in the
PID feedback value.
Set H3-05 or H3-09 to C (PID target value). Also, be sure to set H6-01 (pulse train input
function selection) to 1 (PID feedback value).
Set MODBUS bit 1 in register address 000FH to 1 to be able to use register number
0006H as the PID target value.
Set H6-01 to 2 (PID target value).
Set H3-09 (Multi-function Analog Input Terminal A2 Selection) or H3-05 (Multi-func-
tion Analog Input Terminal A3 Function Selection) to B (PID feedback).
Set H6-01 to 1 (PID feedback).
Adjust PID target value and PID feedback value using the following items.
• Analog input: Adjust using the analog input terminal gain and bias.
• Pulse train input: Adjust using pulse train scaling, pulse train input gain, and pulse train input bias.
Control Method
Setting Conditions
Setting Conditions