YASKAWA G7 Series Technical Manual page 78

Drive Mode Indicators
The definition of the Drive mode indicators are shown in Table 3.2.
Indicator
FWD
REV
REMOTE SEQ
REMOTE REF
ALARM
REMOTE Sequence (SEQ) Indicator
The status of the "REMOTE" Sequence (SEQ) indicator is shown in Table 3.3. This indicator is always "Off" when the Drive is
in the "LOCAL" mode. When the Drive is in the "REMOTE" mode, the SEQ indicator status is dependent on the setting of
parameter b1-02 (Run Command Selection). See Table 3.3.
Indicator Status
REMOTE Reference (REF) Indicator
The status of the "REMOTE" Reference (REF) indicator is shown in Table 3.4. This indicator is always "Off" when the Drive is
in the "LOCAL" mode. When the Drive is in the "REMOTE" mode, the REF indicator status is dependent on the setting of
parameter b1-01 (Frequency Reference Selection). See Table 3.4.
Indicator Status
-4
3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Lit when a forward run command is input.
Lit when a reverse run command is input.
See Table 3.3.
See Table 3.4.
Lit when a fault has occurred. Flashes when an Alarm has occurred.
Table 3.3 REMOTE Sequence (SEQ) Indicator
Parameter b1-02 (Run Command Selection) is set to terminal strip, communications, or an option
board as indicated below:
On b1-02 =1 (Terminals)
=2 (Communications)
=3 (Option PCB)
Parameter b1-02 (Run Command Selection) is set to Digital Operator as indicated below:
Off b1-02=0 (Operator)
Table 3.4 REMOTE Reference (REF) Indicator
Parameter b1-01 (Frequency Reference Selection) is set to terminal strip, communications, option
board, or pulse train as indicated below:
On b1-01 =1 (Terminals)
=2 (Communications)
=3 (Option PCB)
=4 (Pulse Train)
Parameter b1-01 (Frequency Reference Selection) is set to digital
Off operator as indicated below:
b1-01=0 (Operator)
Table 3.2 Drive Mode Indicators
Definition
Condition
Condition